Surprisingly, some of the display homes (I won't say which builder!) have some pretty poor detailing when you look up close - one of the houses we saw, I swear the bricking on the balcony pillars was done using all the crappy brick sides facing out! For those who haven't looked at a single brick closely, there's at least one nice "face" side which should be facing out, and at least one "crappy" side which is usually facing "inwards" and hidden by the frame. Lots of overspray in one house, where the gloss paint from the door architraves was all over the adjacent wall, and no-one seemed to have picked that up. Bad brickwork was everywhere, lots of bricks not flush with each other plus mortar blowouts. Bad tiling in wet rooms, with tiles not flush, sticking up enough to catch your feet. Plenty of doors that didn't close properly, with latches not catching and holding the door shut. Feature wall painting done badly with ragged edges. Anyway, the point is, don't think your house should be of "display home quality" because your house should be a lot better!
Anyway, some photos... one of the Metricon display homes we went into had the right solution to the little question about doors opening against each other. In this pic, the door to the bathroom opens towards the door to the shower.
To stop the door smashing into the shower door, a little stopper is put on the back of the door itself - a simple, elegant solution, and it works. If our bathroom door is left "stopperless", we can just pick up one of these stoppers somewhere and fit it ourselves easily. Actually, we'd probably go and buy a whole lot of nice designer stoppers to replace the little rubber bumpers stuck on the plaster, a lot more durable I think.
In another house, saw a super cool, almost built-in wine rack in an alcove near the kitchen.
Quite clever - each 2 bottle holder section can link into another, secured with a single metal rod running down the centre of it all. Readers - has anyone seen this kind of wine rack before and know where we can get it from? Or can suggest any other funky wine holding solution?
And finally, a couple of the Metricon display homes in Mernda have rainheads (the little box above the downpipes, used for draining flat roofs or balconies). Our inspector picked up that our rainhead coming off the balcony doesn't have an overflow, which is just a hole cut into the rainhead to allow excess water to gush out the side. Both these rainheads have overflows - though even these are probably a little undersized, as they're meant to be the same diameter as the downpipe. Anyway, a pretty easy fix for our house as it just needs a hole cut in the side of the rainhead - takes about 3 seconds using a drill and fine-toothed holesaw bit - but another thing to check off the list at PCI.
The point is, the overflow hole is there to provide an escape route in case there's sooooo much water coming through the gutter, so the water comes out the side rather than backing up and flooding the flat roof or balcony, which then would end up flooding your internal walls - a bad thing! Who would've thought a little hole would be so useful!
T&T
